Just a few clicks
to your desired product.
Our product finder will help you find the right standard valve. Just a few clicks will guide you through our wide range of products to your desired product.
Not found what you are looking for? Our range of valves goes much further. Please contact us directly for special products and individual consulting.
Filter the results
Showing 13–18 of 38 results
ANSI gate valve, forged design
“The JC Valves gate valves are designed with either a bolted or pressure seal bonnet and a flexible wedge. The valve can be produced with nominal diameters greater than 2 1/2”. The valve is designed with an outside screwed stem and according to ANSI.
The JC Valves ANSI gate valves are mainly used in the oil and gas, chemical, petrochemical, energy and mining industries.”
ANSI on/off and control valve (gland seal / bellows seal)
“JC Valves shut-off and control globe valves with a gland packing seal are made with either a bolted or pressure seal bonnet. Both variants are designed in such a way that the disc and seat can be replaced.
The valve has an outside screwed stem in according to ANSI.
The shut-off and control globe valves are mainly used in the oil and gas, chemical, petrochemical, energy and mining industries.”
ANSI piston check valves
“The JC Valves piston check valve R800 is designed with either bolted (NPT) or welded (SW) ends.
The piston check valve is mainly used in the oil and gas, chemical, petrochemical, energy and mining industries.”
ANSI Schmutzfänger ( Guss- oder Schmiedekonstruktion)
The Flowtec ANSI strainer valves are used to filter out solids from the medium. They are available in different mesh sizes. Special designs are also possible.
ANSI swing check valve
“The JC Valves check valve is designed with either a bolted or pressure seal bonnet. Both variants are designed in such a way that the disc and seat can be replaced. The valve is designed according to ANSI.
These housing check valves are mainly used in the oil and gas, chemical, petrochemical, energy and mining industries.”
Ball segment valve PN100-Series
“The ball segment and shaft of the Somas ball segment valve series PN100 consist of one piece. The seat is pressed against the ball segment by a spring element. This enables very good sealing, even at low differential pressures.
The valve housing of the Somas wafer type ball segment valve consists of one piece with nominal diameters DN25/5 up to DN 50 and is divided diagonally with nominal diameters DN 80 up to DN 150.”