Just a few clicks
to your desired product.
Our product finder will help you find the right standard valve. Just a few clicks will guide you through our wide range of products to your desired product.
Not found what you are looking for? Our range of valves goes much further. Please contact us directly for special products and individual consulting.
Filter the results
Showing 31–36 of 42 results
DIN strainer, forged
Wakmet strainer valves made of forged steel reliably protect pipes and components from contamination and damage.
Wakmet strainer valves can be supplied with a drain plug on request.
Depending on the model, the temperature ranges extend up to 530°C (up to ≤ 200°C for PTFE).
The Wakmet metal seated DIN strainer valves (Type 822/ 823/ 912/ 922/ 932) are mainly used in the energy sector as well as in the pulp and paper industry.
Depending on the type, they are suitable for media such as water, steam, acids, alkalis, non-aggressive and non-toxic media as well as some also for gas, fuel and sea water.
DIN swing check valve, forged
Wakmet check valves prevent the backflow of medium into the pipe.
The forged welded design prevents material defects such as cracks or porosity and excludes non-metallic impurities.
A completely open disc provides a full bore so the flow rate remains unaffected. A version with a bypass valve is available on request.
The metal seated DIN check valves KZS/KZK are mainly used in the energy sector for energy applications as well as in the pulp and paper industry.
Disc check valve
Low noise control butterfly valve
“The Somas butterfly valve type VSS LN is a low-noise control valve with a metal seat. With the “”low-noise” noise-reducing device, flashing and cavitation problems can be eliminated and low noise levels can be achieved.
The wafer valve is designed for a wide range of liquids, gases and steam at temperatures up to 550°C.
“
Metal seated butterfly valve for exhaust gas applications
“Somas has developed a range of metal seated butterfly / shut-off and control valves for exhaust gas applications that meet the requirements of EN 12516-2 and ASME B16.34.
Typical applications for these valves in diesel engines, gas engines and exhaust gas systems are:
waste gates, EGR, turbo shutdown, slow steaming, air bypass, gas scrubbers, heat recovery
Somas exhaust gas valves have many technical advantages.
The geometry of the disc is designed in such a way that it only comes into contact with the seal when it is fully closed. This ensures that the wear on the sealing surface is kept to a minimum and a long service life is guaranteed.
The valves have a solid seat design and are therefore resistant to clogging.
The shaft bearings are designed as standard in metal-to-metal pairs, which means that the valves can be used without any problems in high temperature applications.
All valves are supplied as standard with a graphite gland. Other materials are available.
Somas VSS / HT and MTV / HT valves are bi-directional and can therefore be installed in both directions.”
Metal seated DIN swing check valves
“RT gate valves valvole in cast design are used to prevent backflow in pipe systems. Due to their fully open design, this results in minimal pressure drop.
Design:
* The housing material is made of cast steel. The valves have a bolted or pressure seal bonnet (for higher pressure).
* The valve disc is made with forged material. On request, the disc can be supplied with an overlay of Stellite or other materials.
* The disc hinge joint is designed in such a way to achieve a
perfect tightness, which means a self-positioning disc system. “