Just a few clicks
to your desired product.
Our product finder will help you find the right standard valve. Just a few clicks will guide you through our wide range of products to your desired product.
Not found what you are looking for? Our range of valves goes much further. Please contact us directly for special products and individual consulting.
Filter the results
Showing all 2 results
Pinch valve aiRFlex®
“The aiRFlex® pinch valve is designed for abrasive, corrosive and scaling sludge, liquids and powders.
It is characterised by a full bore and it is interchangeable with most ball valves and diaphragm valves.
Technical advantages:
* Patented expansion folds prevent stretching. This reduces the stress on the tube and significantly increases the service
life
* No moving parts – tube is the only wear part.
* Trouble-free operation – no blocking or clogging.
* Increased service life of the tube, which does not stretch when closed.
* Cost-effective solutions as no actuator is required.
* The tube can be replaced without having to remove the valve from the line, thus guaranteeing low maintenance and operating costs.
Operating pressure about 2 bar below
the available factory air supply, up to
max. 6 bar.
The MONSYS monitoring system prevents
unexpected emergency repairs.
“
Pinch valve RF VALVE
“The pinch valve RF is designed for abrasive, corrosive and scaling sludge, solids, liquids and powders.
It is characterised by a full bore and it is interchangeable with most ball valves and diaphragm valves.
The MONSYS monitoring system prevents unexpected emergency repairs.
Technical advantages:
* Patented expansion folds prevent stretching, thus reducing the stress on the tube and significantly increasing the service life.
* No moving parts so the tube is the only wear part.
* Trouble-free operation: no blocking or clogging.
* Increased service life of the tube, which does not stretch when closed.
* Cost-effective solutions as no actuator is required.
Available in nominal diameters from DN25 – DN 1500
The tube can be replaced without having to remove the valve from the line, thus resulting in low maintenance and operating costs.
Actuator types: pneumatic, electric and hydraulic”
* Kostengünstige Lösung, da kein Antrieb benötigt wird.
Erhältlich in den Nennweiten DN25 – DN 1500
Der Schlauch kann gewechselt werden, ohne daß die Armatur aus der Leitung herausgenommen werden muss, was in niedrigen Wartungs- und Betriebskosten resultiert.
Antriebsarten: pneumatisch, elektrisch und hydraulisch”